Twisty the Clown - American Horror Story Freakshow

auzorann

Well-Known Member
here's a Twisty the Clown half mask that I sculpted recently. it's slush cast in urethane resin. i'm not much of a sculptor but i don't think it turned out too bad.

IMG_0863.jpgIMG_0862.jpgIMG_0861.jpgIMG_0858.jpgIMG_0860.jpgIMG_0859.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top