Star Trek Voyager Long Blue/Metallic Medical Device

renaissance_man

Master Member
RPF PREMIUM MEMBER
Used throughout the series, this is another of the medical props that has been on the back burner far too long.


The metal parts I had machined up quite some time ago by a guy here in the UK and then I modelled up and 3D printed the other components and then cast a 10-turn for the sides.
The electronics are fairly simple and as you can see I have tested the wire length for the push button inside the aluminium rod section.


Voyager%20med%20device_zpskcdqm7jl.jpg



Still at least 2 more Voyager medical props to show, so stay tuned!
 
I gave the parts (excluding the battery cover) another prime coat today just to tidy them up a bit.


voyager%20medical%20device_zpsddf9qg8a.jpg



For the most part the electronics have been worked out, I just need the time to finish it off!
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top