ASHPD (Portal Gun) pepakura model

bevbor

New Member
Well, I modeled ASHPD (Portal Gun) and I think this model is very smooth. It is fully unfolded and ready to build.
(Press on picture to enlarge)


The model was done in SolidWorks:
(Press on picture to enlarge)


DOWNLOAD PDO THERE
 
Last edited:
*reads username again* Oh wait, you're bevbor! :p

Saw your full sized Banshee, did you ever do anything to it other than the cardboard?
 
Bevbor,

excellent pep, thanks for sharing!

I moved this thread to the main prop forum, since it´s definitely a prop project worthy to be shown off!

Michael
RPF staff
 
Well guys,
I started to put ASHPD pep together, and, as always, to check overall build-ability of this model, started from most difficult part - shells =)

(Press on pictures to enlarge)




 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top