Pixels
Active Member
My progress on this is pretty much halted until I get my angel blade, since the size of the unit is going to be relative to the size of the blade and where it needs to be supported.
I'm not going with any kind of bulb just due to the size of them. I want the smallest, most controllable, direction-able light I can get which is going to be some configuration of LEDs.
I'll use breadboard for the LEDs and build in a switch. Ideally I'd like to use a 3-setting switch and have it powered by a mains adaptor.
I'm not going with any kind of bulb just due to the size of them. I want the smallest, most controllable, direction-able light I can get which is going to be some configuration of LEDs.
I'll use breadboard for the LEDs and build in a switch. Ideally I'd like to use a 3-setting switch and have it powered by a mains adaptor.