Sure thing. From top to bottom/left to right then:
The Hi-Tek belt. My girlfriend bought it and had it shipped here, all I had to do was punch all the extra holes in it and cut it to length.
Two pill cases. One needs the red anodized finish sanded off. They're not IDENTICAL to the real ones, but pretty close. Then we have some .75" black elastic, some aluminum plates that are cut to size but don't have the holes drilled yet. The clip next to those isn't identical to the one on the screen used belt, that one has a weird cross base on it and we weren't able to find it. They came in a pack of 5 though, and they do match the other two clips on the back of the belt. Some chain, inaccurate and will be replaced later, and the whisk.
On the middle right we've got some 1/2" packaging foam and a clay sculpt of the bit that goes in the center of those two boxes. I'll clean it up and mold it to pour two casts later. Below that we have accurate headphone wires to go into it and the zip ties that hold them to the belt.
The bottom row we got as close as possible. On the far left is a reading glasses case. I might try to polish up the cap a little to match the one on the belt. After that is a vintage flashlight. Found out later that it's actually a 6" sink tube on the real belt, but she didn't want to change it. Next is what I've been referring to as box 3, which is a black plastic box with a multi-layer metal face plate, two silver tubes, and a metal H-shaped block. This one is barely completed yet. The is box 2, which was a piece of wood she cut to shape, I haven't finished the face plate yet, it's being made from layers of styrene, then I'll mold and cast it. Then box 1, which is pretty much done. Random model car engine parts stuck to a styrene plate. It's short a screw.
This project has been temporarily put on hold. My girlfriend got really sick and she's not going to make it to Gally, so it's being put off probably until Convergence in July. Gives us plenty of time to get it just right.