P4r4dox86
Well-Known Member
I've finally made mine up for my Avengers Cap, WIP and finished pics are in the thread in my signature
@Billymaya: I used the SmoothOn 65D process on mine, it worked fairly well however there was a bit of an issue with it running down the curves of the helmet and not coating properly (pics of what I mean are in my thread). I would suggest if you're going to go that route that you coat in fairly 'flat' areas, ie I ended up breaking the main curve from front to back into 3 sections and coating them one at a time so that they could be put in a relatively flat position so that the coating didn't run and pool.
@Billymaya: I used the SmoothOn 65D process on mine, it worked fairly well however there was a bit of an issue with it running down the curves of the helmet and not coating properly (pics of what I mean are in my thread). I would suggest if you're going to go that route that you coat in fairly 'flat' areas, ie I ended up breaking the main curve from front to back into 3 sections and coating them one at a time so that they could be put in a relatively flat position so that the coating didn't run and pool.