gcngamer128
Well-Known Member
I create the 3 sections that will come together to form the microphone on the front of the mask. The 3 sections were Plastic Welded together and the seams were covered in Bondo. When they are sanded, they will be glued down, and a mesh insert will complete the interior and create a microphone-like mass.
Using the Pepakura templates, I cut out the item using styrene plastic. After it was glued on, the item was then fiberglassed to the mask, and then covered with Bondo until I could get a nice round shape to it. It is not yet completed, but is almost there.
Using the Pepakura templates, I cut out the item using styrene plastic. After it was glued on, the item was then fiberglassed to the mask, and then covered with Bondo until I could get a nice round shape to it. It is not yet completed, but is almost there.