Shards of Narsil

PHArchivist

PHArchivist

Master Member
"It's still sharp...!"

I made this yesterday, cut from an Anduril generic. Getting the line of the break was difficult, and I didn't quite nail it. Those who know this prop well will spot the inaccuracy. but the source swoard was a pretty high quaity,a nd the end result is quite satisfying. I like it, and it's lethal!

SoN007.jpg


SoN002.jpg


SoN009.jpg


SoN010.jpg


SoN011.jpg


SoN006.jpg
 
Looks good! Hehe I pull my Narsil pommel off of the plaque all of the time... even though it's just the shattered hilt it still feels nice in-hand.
 
Cut lines look pretty good. :thumbsup
On the Dremel lines I would use some high grit sandpaper and polish it up with Neverdull. It is a polishing substance like cotton but it will buff out to a high shine. I use it to polish all of my aluminum hardware sabers!
Give it a try. You should be able to get Neverdull at Walmart in the automotive section!!:)
 
Where's the rest of the broken sword blade? Are those coming later for a complete display like in the House of Elrond?
 
has any one else done a cutting template yet? I just won my sword on EBay.

I seem to remember some great screenshots of a top down at one here somewhere. If any one has them please post em. I'll work out a template somehow and post it for us all to use.

PH...I love what you did. We are all perfectionists with our own work but I'd be proud to hang it LOL I thought I would cover a long bit of MDF in the same sort of bluey material on the statue stand in the movie, frame it with beading and affix all the shards to it bar the grip. I'll use hooks there for playing with it. Get a lasercut label then Bob's your uncle. Any display ideas guys?

Regards
Christian
 
Trooperdad said:
Where's the rest of the broken sword blade? Are those coming later for a complete display like in the House of Elrond?
Click to expand...


Laying on the floor of my shop! :lol After the hard work and health hazard of cutting the hilt, I lost my motivation to do the rest... Some day perhaps!

Taz, I just printed off a pic of one of the licensed versions and went from there. I tried to get the measurements correct. But template or not, the biggest challenge was acheiving precision custs with the Dremel cutting wheels. Not easy, and I did not suceed perfectly.
 
Good job, Rob :thumbsup. How many cut-off wheels did that take? Did you use the reinforced or regualr?

-Fred
 
Yes indeed! Thanks fo rthe tip on what to print mate:)

I think I might scribe the correct line in to a couple of mill by hand so I get a straight cutting guide for the dremel:)

Regards
TAZ
 
You must log in or register to reply here.

Similar threads

zachsbanks547
My Grail Diary Project
Replies
17
Views
2,409
MichaelFuji
MichaelFuji
feep
Vrataski Unit Dog Soldier Helmet replica from Edge of Tomorrow
Replies
0
Views
767
feep
feep
turner3d
Trek TOS Communicator: Animated Moiré Plans on the Cheap
Replies
10
Views
1,826
Trooper_trent
Trooper_trent
eethan
Leia and Chewie ANH brass handcuffs, project WIP
2 3 4
Replies
63
Views
5,299
eethan
eethan
feep
"Perfect" Edge of Tomorrow Helmet build
Replies
2
Views
1,549
The Kaiser
The Kaiser
Back
Top