From Pep - mold

Thread starter jmorrone
Start date May 6, 2013

jmorrone

New Member

May 6, 2013

Is there a tutorial somewhere that will show you step by step the process from PEP to molding even a small part. I am very new to working with these files and need to know the start to finish process even on a very small part so I know if this is something I can handle doing, or if I need to think about buying finished parts.

~J

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.