Here's the Nerf Recon clip and you can see the piece I've cut out of another one.
After a bit of dremel work, some sanding with a file...not to bad.
And of course you have to make two of them, but only one Nerf Clip is needed to do it.
I drilled and counter sunk the pieces first, then gorilla glued them on.
Then, when glue was dry and set hard, I drilled again with a smaller bit. The screws would be enough to
hold it on, but I didn't want them to move durring the drilling.
Primer showed a few low's and high's so I'm going to re-sand it all down again...
...but that's tomarow!
PS. There IS one more piece to make for this...anyone know what it is?