River Song's Sonic Screwdriver Complete (Pics in post 1)

Thanks, I guess I will have to make do with what is available

Anyone have any idea about the finger hole? So far I have done:

-The emmiter minus the mold, blue section, and side fins. (I even have the little bar on the inside too.)

-Main Body
-Top handle section/plate area
-Red stone underneath the plate
-Two fins that pop of the side of the handle.

I need to find the rings towards the bottom before I can proceed with very bottom as well.

All it all it is going a lot better than I thought...

-arwa

dude you gota stop teasing us
please show us some pics

The rings could be simple brass washers just polished, maybe a thought?

The ring looks like an adjustable finger rest on the top of a trumpet.

The blue emitter appears to be domed but stepped. As for the brass finger ring? I think it looks a lot like one side of a small pair of scissors.

Here's the best picture I could find.

That is the same picture I have been looking at for the past few days. I was thinking a pair of scissors as well for the ring, but I haven't come across the right size. There is supposed to be a huge "Bananza" tomorrow through Sunday, so maybe I can find the necessary greeblies there.

Pictures are coming...

Awesome job so far, looks great!!!

Thank you. It is a pain to find/make these parts. I think I am going to have the side section on the emmitter done this week. I am probably going to make them out of brass scraps.

I am not sure about the other pieces yet. I am making this up as I go.

-arwa

I am almost done with trigger ring too. I built around the silver ring in the picture above and connected it to the acrylic section. It is really rough right now with a lot dinks and divits. I may leave it that way and just sand down/ smooth over the section closest to the screwdriver body.

It is very awkward to have in my hand. It is like using a pair of scissors on the opposite hand that you would use.

-arwa

bump for update

Looks great! Hopefully we'll see that official repro soon from millenium/eFX then we can start the mods.

I know it has been discussed above, but does anyone have any idea about the light section?

I know it is stepped (thanks for the pic above), but I don't know where to look for it.

Is anyone else working on one of these?

-arwa

Everything is done, but I still can't figure out what the light is.

Anyone?

-arwa

Looks like an old-style power lamp cover to me, got something extremeley similar on my vintage oscilloscope.

Thanks Birdie,

I will keep an eye out for it.

-arwa

Bump for completion I don't think you will mind

Not too shabby at all! One nit pick, get rid of the tubing and replace it with clear acrylic rod. Most plastic shops will have scraps you can get for spare change. Other than that, you've gotten off to a fine start there!

Thanks. The thing about the plastic is that it is attached with the epoxy. There is no way of removing it without destroying the ring section. The other thing is that I don't have any plastic shops around here (Which reminds me, I need to check one of my junkyard posts). the piece that I did have started out clear, but I had to scratch it up to remove a logo on it, so I ended up scratching up the whole thing.

It looks a lot better in person too and after it was put together, it fits really well you both of my hands. I thought it was strange to hold at first, but it is very comfortable after it was assembled.

-arwa