Hey there I have never done any type of replica costume work till now I was inspired by "ROSSKOW's" Boba Fett helmet build which is looking nice and it's his first attempt, my main forte on the RPF here has been making scratchbult models like my APC and Arkham Batmobile kits but I always wanted to try to make some kind of helmet so I started with the templates found on the Dented Helmet site. I layed the cheek bone templates on with spray adhesive on styrene instead of cardboard then I cut them out. I then did the dome with foam sheeting that you can get at the home depot like $20 bucks for an 8 foot piece. The back area was done with layered cardboard I need to adjust the rear profile it's to straight and needs to flare out I put a coat of spackle on the dome to fill in the pores. I will fiberglass the cardboard area or slap resin on it to harden it, and will bondo the dome and will use to Magic sculpt to do the raised areas for the visor area this is my 1st prop so here is where Im at with 2 days of work so we'll see how it turns out.