32 inch Falcon landing gear question...

J

Jedi Dade

Master Member
I'm trying to build a set of landing gear at studio scale for the 32" ESB falcon. Does anyone know the real world model parts used, and/or get some measurements from those parts so that I replicate and scale it correctly?

Thanks,
Jedi Dade
 
only one I can find:

falconlandinggear.jpg
 
they're not model parts. they correspond to the blueprints 1975/76
scratchbuild them
the blueprints have 1:1 scale dimensions. you can scale them from there.
 
Last edited:
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

modelerdave
Falcon 3D parts replacement cockpit dash question
Replies
0
Views
283
modelerdave
modelerdave
Flyscriber
Millennium Falcon Five foot gun turret scratch build.
Replies
4
Views
576
Flyscriber
Flyscriber
G
One More 5 Footer Falcon
Replies
18
Views
1,714
joberg
joberg
RealDaveWinter
5' Falcon base hull building
10 11 12
Replies
220
Views
13,903
Studio Kitbash
Studio Kitbash
1138sw
Fanhome the Falcon returns!!!!
Replies
1
Views
1,224
Junk Pilot
Junk Pilot
Back
Top